Installation Systems

Laminators offers five different panel installation systems to give you the look you need at the budgeted cost you require. Panels can be measured and cut at the job site…no prefabrication or comprehensive shop drawings are necessary. Special panel lengths and widths can be ordered to minimize waste and reduce labor and materials expenses.

Omega-Lite installed in our 1-Piece, Tight-Fit, Dry Seal, and Rout & Return installation systems meet NFPA 285, Miami-Dade County Product Control and Florida Product Approval requirements.  Our 6mm core passed NFPA 285 tests without the need for a special, fire-retardant core. 

Click an image below to learn more about our installation systems.

1-Piece, Tight-Fit Molding

An easy and economical, progressive installation system using a combination of "J", "H" and/or "H-Reveal" moldings.

2-Piece, Snap-Fit Molding

A non-progressive molding system where molding receptors are installed in a grid-like fashion prior to panel installation.

Clip & Caulk™

An economical method to achieve a Rout & Return look without the costly expense to fabricate.

Dry Seal

High performance pressure-equalized rainsceen that creates a "deep reveal" look without applying caulk at the joints.

Rout & Return

Sophisticated high-tech look utilizing a backer rod and caulked joint to create a "deep reveal" or flush monolithic appearance.

Omega-Flex™ Curve Treatment

Radial panel installation without costly off-site roll-forming required.