Testing & Certifications
NFPA 285 with 1-Piece, Tight-Fit Molding System Over Omega CI®
Laminators Incorporated has met the conditions of acceptance of NFPA 285 for its 1-Piece, Tight-Fit Molding installation system with back-drained and ventilated subframing over Omega CI®.
NFPA 285 with 1-Piece, Tight-Fit Molding System Over Gypsum Sheathing
Laminators Incorporated has met the conditions of acceptance of NFPA 285 for its 1-Piece, Tight-Fit Molding installation system with back-drained and ventilated subframing over gypsum sheathing.
NFPA 285 with Clip & Caulk System Over Omega CI®
Laminators Incorporated has met the conditions of acceptance of NFPA 285 for its Clip & Caulk installation system with back-drained and ventilated subframing over Omega CI®.
NFPA 285 with Clip & Caulk System Over Gypsum Sheathing
Laminators Incorporated has met the conditions of acceptance of NFPA 285 for its Clip & Caulk installation system with back-drained and ventilated subframing over gypsum sheathing.
Miami-Dade NOA - Expires 08/2020*
*NOTE: Due to delays associated with COVID-19, our renewal is pending.
Laminators Incorporated has received a Notice of Acceptance (NOA) from Miami-Dade County Product Control Section for Omega-Lite ACM panels installed with a variety of the company’s installation systems under NOA #18-0214.03, expiring on August 20, 2020*.
Each applicable installation system met the requirements of the small and large missile impact testing using Laminators Omega-Lite ACM panel over a plywood substrate, and are approved for use in all HVHZs with a design wind pressure of +/- 120 pounds per square foot.